Stihl RE 120 - 12 After Finishing Work

0458-620-0121-A
25
English 12 After Finishing Work
► If a nozzle is fitted to the spray lance (3): Remove the
nozzle.
► Attach the spraying set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water before cleaning
them.
► Squeeze spray gun trigger and spray detergent onto the
surface to be cleaned.
► Apply the detergent starting at the bottom and working up
and do not allow to dry.
► Remove spraying set.
► Attach the nozzle.
► Clean the surface.
RE 120
► Meter out and use the detergent as described in the
detergent Instruction Manual.
► Fill bottle (1) with max. 500 ml of detergent.
► Screw spray nozzle (2) onto the bottle (1) and tighten
hand-tight.
► If a nozzle is fitted to the spray lance (3): Remove the
nozzle.
► Attach the spraying set (4) to the spray lance (3).
► Turn adjusting ring (5) to set the required metered
quantity of detergent.
► Turn the adjusting ring in the + direction: Detergent
addition is increased.
► Turn the adjusting ring in the - direction: Detergent
addition is reduced.
► Soak extremely dirty surfaces with water before cleaning
them.
► Squeeze spray gun trigger and spray detergent onto the
surface to be cleaned.
► Apply the detergent starting at the bottom and working up
and do not allow to dry.
► Remove spraying set.
► Attach the nozzle.
► Clean the surface.
12.1 After finishing work
► Switch off pressure washer and unplug mains plug from
the socket.
0000-GXX-5097-A0
4
3
500 ml
400 ml
300 ml
200 ml
100 ml
0000-GXX-5098-A0
2
1
12 After Finishing Work
5
0000-GXX-4363-A0
500 ml
400 ml
300 ml
200 ml
100 ml
4
3