0478 131 8365 C - EN
90
Divided mowing area – the robotic mower
cannot travel independently from one
mowing area to the other.
Docking station:
Location (1) directly next to the houses A
No-go areas:
Installation around the free-standing tree
and around the vegetable patch B based
on a linking section installed at right angles
to the edge.
Wire clearances: (Ö 12.5)
Clearance to adjoining area that can be
travelled on (e.g. patio) with a stepped
area height of less than +/- 1 cm: 0cm
Clearance to high obstacles: 28 cm
Clearance to the tree: 28 cm
Minimum wire clearance in the confined
areas behind the vegetable patch: 44 cm
Secondary area:
Installation of a secondary area C, linking
section (3) on the patio accommodated in
a cable duct.
Programming:
Define the size of the mowing area
(without secondary area), program one
starting point (4) in the confined area for
using the offset drive home function
(Ö 11.13) – starting frequency 2 of 10
operations (Ö 11.14)
Points to note:
Bring the robotic mower to the secondary
area several times per week and activate
the "Start" menu. (Ö 11.5)
Take the mowing performance into
account. (Ö 14.4)
If necessary, install two separate mowing
areas with 2 docking stations.
To Next Page
Loading...
Need help?
General
