7 PI 70 en26 | Prism PI
StoneL publication 105431revC
5.7 Federal Communication Commission (FCC) statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
Contains FCC ID: PI4BL600
FCC Radiation Exposure Statement
This equipment is in compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had been tested in
accordance with the measurement methods and procedures specied in OET Bulletin 65 Supplement C.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
Caution: Any changes or modications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
To Next Page
Loading...
