StoneL Prism PI - 1 General; Introduction; Title Plate Markings; CE Markings

StoneL publication 105431revC
7 PI 70 en Prism PI | 3
Lo go
Warning:
Note:
Sensor Ratings:
Haz. Loc.: CI I, Div 1, Gp B, C, D; CI II, Div 1, Gp E,F,G;
sample only
Approval markings
Serial
Model
Date
™
1.2 Title plate markings
The Prism PI has an identication plate attached to the cover.
1. Identication plate markings:
2. Model
3. Serial number
4. Date
5. Electrical rating(s)
6. Protection class information*
7. Note
8. Warning
9. Approval markings*
10. Logo
Note
* See page28 for specic product markings.
1 General
1.1 Introduction
This manual incorporates the Installation, Maintenance and Operation (IMO) instructions for the Prism PI series valve controllers. The Prism PI is
designed to provide position feedback indication and pneumatic control of on/o automated valves.
Note
The selection and use of the Prism PI in a specic application requires close consideration of detailed aspects. Due to the nature of the product,
this manual cannot cover all the likely situations that may occur when installing, using, or servicing the Prism PI. If you are uncertain about the use
of this device, or its suitability for your intended use, please contact StoneL for assistance.
1.3 CE markings
The Prism PI by StoneL meets the requirements of European Directives
and has been marked according to the directive.
1.4 Recycling and disposal
Most Prism PI parts can be recycled if sorted according to material.
In addition, separate recycling and disposal instructions are available
from us. A Prism PI can also be returned to us for recycling and
disposal for a fee.
1.5 Safety precautions
Do not exceed the permitted values! Exceeding the permitted values
marked on the limit switch may cause damage to the switch and to
equipment attached to the switch and could lead to uncontrolled
pressure release in the worst case. Damage to the equipment and
personal injury may result.
To prevent ignition of hazardous atmospheres, replace cover before
energizing the electrical circuits. Keep cover tightly closed when in
operation.
10
5
8
1
7
3
9
6
2
4