STONEX S580 - Page 13

Stonex S580 GNSS Receiver – User Manual 13
In the Observation Settings subsection, you can start and stop the record of the raw data and configure the registration
options. You can record raw data even while you work in Rover SBAS or External (RTK), or while working as base.
Interval: set the frequency/time interval between the registration epochs (max frequency while working as base is 1Hz);
Duration time: set the duration of the single observation file. Ex. If you set 15 min, after 15 min from the start of the
registration, the observation file will be closed and another one will be open. This will continue until you stop (disable) the
raw data recording.
Point name: this will be visible in the Observation file header, maximum 4 digits.
Antenna Height: this will be visible in the Observation file header, the unit of measure is millimeters, the measure must be
taken to the bottom of the device.
.