Stonex S580 GNSS Receiver – User Manual 12
3.3 Set section
In the Working Mode page, you can set the Work mode and the Observation settings.
In the Work mode subsection, you can choose between Rover or Base.
The Rover settings are basilar: you can choose to receive the correction from Bluetooth (External), to use the informations
from the SBAS satellite or to not receive corrections (No Datalink)
The Base settings let you choose:
• the Site Id (up to 3 digits)
• the Base position: Single: the receiver will use
the position at the moment of the base
startup, Repeat Position: the base will use the
coordinates specified in decimal degrees
Ex.
To connect to the SR02 external radio you must scan for
the Device list and select the serial number of the radio.
For the SR02 configuration refer to the section 4.2 of
this manual.
To Next Page
Loading...
