Need help?Do you have a question about the STONEX S10 and is the answer not in the manual?
Details the meaning of LEDs on the STONEX S10 smart panel for status indication.
Describes the 5-pin and 7-pin LEMO ports and antenna connectors on the receiver.
Details the battery housing, SIM slot, SD card slot, and reset key on the receiver's back.
Describes batteries, charger, and adapter for powering the STONEX S10 receiver.
Details UHF and GSM/WCDMA/EVDO antennas, including external options.
Lists communication cables, auxiliary cables, and external power supply cables.
Covers poles, brackets, tribrach, and measuring tape for setup and calibration.
Information on the STONEX S4C/H controller, which is ordered separately.
Step-by-step instructions for setting up the receiver as a base or rover.
Explains the F key and I key for changing modes and power control.
Procedure for downloading static survey data via USB connection.
Guide on connecting to the receiver's web interface via Wi-Fi.
Details how to configure working modes and general device settings via WebUI.
Configuration options for Rover mode: UHF, Network, and External.
Configuration options for Base mode: UHF, Network, and External.
Settings for language, time, speaker, storage, and other device parameters.
How to activate and configure NMEA sentences for data output.
Comprehensive guide for calibrating the electronic bubble and tilt sensor.
Detailed steps for calibrating the electronic bubble sensor.
Detailed steps for calibrating the azimuth sensor.
Procedure for calibrating the magnetic declination for accurate measurements.
Table of default UHF radio frequencies for channels 1-8.
Solutions to common problems encountered with the receiver.
Detailed specifications for the receiver's hardware and performance.
Information on copyrights, limited warranty, and environmental disposal.
Guidelines, warnings, and cautions for the safe use of the equipment.
To Next Page
General
