6. Appendix
Appendix 1: STONEX S10/S10N electronic bubble and tilt
sensor Calibration procedure.
One of the most innovative features of Stonex S10 GNSS is the high sensitivity
tilt sensor, embedded in the receiver.
This feature dramatically increase the speed of the field works and the
accuracy of any measurement.
Thanks to the tilt sensor the Surveyor can check the vertical position of the
rover directly on the Controller’s display, and survey points even in case the
position of the GNSS is not vertical and the measure must be done with the
pole in tilted position.
Accurate measurements require an accurate calibration of the tilt sensor: when
the User needs to use the tilt sensor capabilities, the first calibration must be
done, and only in case of completely different work environments a second
calibration procedure is suggested (i.e., when S10/S10N are used thousands
of Km far from the location of the previous calibration). The following notes
help the User to perform a perfect calibration; in case of need, the User can
contact the Authorized Stonex local Dealer or mail to Support@stonex.it.
What is needed to calibrate S10/S10N
To Next Page
Loading...
