Stonex S10 GNSS Receiver – User Manual 18
Successful Self-check: it means that modules work properly if every led
is lit and the voice broadcast that module is succeed in self-checking
(Such as “GPS OK”). The receiver will automatically reboot in 5 seconds
after finish all the self-check modules and will begin to work.
Note: The frequency setting of the internal UHF module is set back to factory
default on self-test. Please contact your local dealer to obtain the frequency
information in your country.
4.3. How to download static data
Static data can be downloaded through WebUI interface or using the USB
cable. For a correct connection between receiver and PC, follow the procedure
described below.
First turn off the receiver, then connect the cable to the communication
interface of the receiver (7-pins Lemo port), then insert the USB port in the PC.
Turn on the receiver. The taskbar will show as follows:
Fig. 4.3 - Taskbar of windows including the receiver
The PC considers the receiver as a “media disk”, so open the “media disk”, and
then you can get the data files in the memory.
To Next Page
Loading...
Need help?
General
