STONEX S10 - Option Network

Stonex S10 GNSS Receiver – User Manual 30
 Baud rate: must be congruent with the protocol and the selected band
(Selectable from a minimum of 4800 to 19200 bit/s)
 CSMA: to prevent transmission if the selected channel is already
occupied.
 FEC (forward error corrector): Used primarily with radio protocol Satel.
Introduces the information that make more "robust" the radio message,
making it less susceptible to interference.
 Scrambler: used mainly with Satel protocol.
 Area: Makes the receiver fully complaint with the rules of the
geographical area.
Use the "SAVE" button in the lower part of the screen to save the
configuration.
5.4.2. Option Network
The Network option gives the possibility to get differential corrections through
the GPRS modem; the auto-connect option to the UMTS network after
completed the power on process of the receiver can be activated.
NTRIP operating mode requires the same types of settings given previously
for the rover mode (address of APN, Caster address, Port number, Mount
Point, user ID and password of user to access the provider NTRIP).
The CSD option in "Connect Mode" enables the operation of the base in direct
call with the rover. In this case it must also be selected the box that enables
the automatic start of the base, when completed the start-up phase.