EasyManuals Logo

STONEX S10 User Manual

STONEX S10
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Stonex S10 GNSS Receiver User Manual 17
Changing the working mode and data link
When Stonex S10 is switched on, press F key and very quickly the Power key,
if the speaker is enabled S10 broadcasts “change working” and all the leds
start to blink at the same time. Then release both keys.
Change working mode:
Every time F key is pressed, S10 broadcasts “static”, “rover” or “base”, and the
related Led is blinking (static led blinking in the first case and GSM and radio
led blinking at the same time in the case of “rover” or “base”). Confirm the
desired option by pressing power key.
Change data link:
After confirming the working mode, receiver will broadcast: “Change data link”
and GSM, RADIO and power key start blinking at the same time.
Every time F key is pressed, S10 broadcasts “Radio”, “network” or “external”
and the corresponding led blinks, user can confirm the data link desired by
pressing power key once.
After confirming the working mode, receiver will broadcast “set Wi-Fi if
speaker is enable and Wi-Fi and power led will blink ad the same time. By
pressing F key, user can enable or disable Wi-Fi, after choosing the option
confirm by pressing power key.
Self-Check: it is a procedure predisposed for verifying the correct working of
the instrument device. The program is mainly to predict whether the receiver
modules work normal ahead of time or not. S10 self-checking part includes
GPS, WIFI, Bluetooth, radio, network and sensor; a total of six parts.
- When the receiver is on, long press and hold I key until you are prompted
turn off the device and release it, then long press I key again. You will
hear the beep to voice broadcast self-check and release it, then the
receiver carry out self-check including GPS module, UHF module, and
GPRS module.
- Self-check lasts typically around 1 minute. In the process of self-check, if
you have failure in one module, and the voice broadcast the module does
not work normal, this module led will continue to beep, until the user
restart the receiver. If you have found it, please contact Stonex.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the STONEX S10 and is the answer not in the manual?

STONEX S10 Specifications

General IconGeneral
BrandSTONEX
ModelS10
CategoryReceiver
LanguageEnglish

Related product manuals