Stonex S700A GNSS Receiver – User Manual 13
When receiver is powered on, press power button and hold it until the
receiver voice broadcasts “power off”. Press it again until the receiver sounds
a beep and voice broadcasts “self-check”, which means the receiver starts to
operate self-check. New receiver is recommended to operate self-check at
least once.
In the process of self-check, each module inspection is followed by its
inspection result. If the module inspection passes, it will voice broadcast “OK”
and module led keeps on until the whole self-check finishes. If the module
inspection fails, it will voice broadcast current module inspection fail, keep
module led flashing and buzzer sounding until you restart the receiver. Self-
check lasts for about 1 minute. If there is self-check failure, please contact
local dealer.
If every module indicator is lit with no flashing, and voice broadcast says
every module work normally (such as “GPS self-check. OK.”), it means all the
modules work normally. Receiver starts to work after the whole self-check
finishes
3.5 Insert SIM card
If you need to use the SIM card, you should insert the SIM card before you
power on the S700A; open the card cover first, then insert the SIM card as
the notes in card cover.
To Next Page
Loading...
Need help?
General
