STOROpack AIRmove2 - Fitting a New Film Roll; Initial AIRmove² Parameter Set-Up

AIRmove
2
- Perfect Protective Packaging 10
7.4 Fitting a New Film Roll
Make sure the machine is not running while changing rolls!
If there is an empty roll on the machine, remove it from the film roll holder. To fit a new film roll, please
proceed as follows: Slide the new film roll onto the film roll holder. Ensure that the film is oriented to unwind
from the underside of the roll.
The film roll has continuous cross perforations and a non-continuous cross-seal. There is a gap between the
edge of the film and the perforations.
Cut a little corner off the film gap. Slide the gap over the white injector. Turn the unlock knob clockwise to
unlock the top sealing unit. Slide the film between the sealing units as far as possible until you feel
resistance.
Turn unlock knob counter clockwise to lock the top sealing unit. Always make sure that the knob is locked to
ensure a good seal quality!