STOROpack AIRmove2 - AIRmove² Safety Guidelines; Electrical Safety Precautions

AIRmove
2
- Perfect Protective Packaging 4
1. Introduction
This user manual has been compiled by STOROpack with all due care to enable safe and fault-free
production of air pillows with the AIRmove
2
machine. Before operating AIRmove
2
, familiarize yourself with
the contents of this user manual to guarantee safe operation. When the AIRmove
2
is in operation, the user
must ensure that nobody will be bodily damaged due to unauthorized intervention into the production
process.
2. Safety Instructions
To guarantee personal safety, the following instructions must be carefully observed:
1.) Work Area
a. Keep the work area clean and well lit. Cluttered and dark areas invite accidents.
b. Place the AIRmove
2
machine on a flat, dry surface.
c. Do not operate AIRmove
2
in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Do not place flammable materials in, on or around the
machine.
2) Electrical Safety
a. The power plug must match the outlet and the outlet must be appropriately grounded. Do
not modify the plug in any way. Do not use adapter plugs or extension cords.
b. Do not expose the AIRmove
2
machine to wet conditions. As with any piece of electrical
equipment, operating the machine when wet will increase the risk of electrical shock.
c. Do not abuse the power cord. Never use the cord for carrying, pulling or unplugging the
AIRmove
2
machine. Keep cord away from: heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electrical shock.
d. For installation and maintenance work, the machine must always be turned off by the main
switch and be disconnected from the main power connection. The machine operator must
avoid any contact with the electrical parts.
e. All safety and protective measures and facilities must have been applied and be
maintained in accordance with IEC instructions (International Electrotechnical
Commission).
f. The machine instructions are provided by STOROpack’s own staff or staff delegated by
STOROpack. STOROpack’s liability under IEC regulations no longer applies if changes or
additions are made to the machine without STOROpack’s permission.