STOROpack AIRmove2 - Personal Safety Measures; AIRmove² Usage and Care Instructions

AIRmove
2
- Perfect Protective Packaging 5
3) Personal Safety
a. Stay alert, watch what you are doing and use common sense when operating the
AIRmove². Do not use AIRmove² when you are tired or under the influence of drugs,
alcohol or medication.
b. Prevent accidental starting. Ensure the switch is in the off position before plugging in.
c. Avoid loose clothing, jewellery, long hair, etc. from contact between the drive wheels. Do
not place anything between the drive wheels other than STOROpack film. This includes
paper, metal, tools, etc.
d. There is an extremely sharp knife blade under the Air injector assembly. As this is a part
that may wear over time and must be replaced, great care must be taken when removing
and handling the blade. Strictly adhere to the blade replacement instructions in the user
manual.
e. The film is sealed by using a heated wire which is located under a Teflon belt. (below the
blue protective covers). This wire gets very hot and may cause burns if touched. During
normal operation the wire is not exposed, but care must be taken when replacing film or
replacing the Teflon belt. Switch the machine off and allow the wire 2-3 minutes to cool
down before performing any operation exposing the wire. Instructions for replacement can
be found in the user manual.
4) AIRmove
2
Use and Care
a. Switch the machine off and disconnect the plug from the power source before performing
any operation to the AIRmove
2
machine. This includes replacing film, cleaning or
maintenance.
b. DO NOT lift using the power cord.
c. The AIRmove
2
machine requires periodic cleaning – more often if operated in dirty or
dusty conditions. Check for misalignment or binding of moving parts, broken parts and
any other condition that may affect the operation. Do not operate a damaged machine.
d. This system was designed for processing a specific film type. In order to guarantee
smooth function, only original STOROpack’s consumables should be used.
e. In emergency situations, set the main switch to “0”. The machine will be switched off
within a few seconds (when indicator is turned off completely). After eliminating the
emergency situation or fault, the machine can be switched on again according to the user
manual.
f. The manufacturer is not liable for any modifications of the machine which are made
without written approval from STOROpack.