p. 13
Daily Care
Daily:
・
Strap Seal・・・・・・・・・・・・ Check the seal for good bond & overlap.
・Abnormal Noise ・・・・・・・・・・ Check for any abnormal noise during machine operation
・Vibration ・・・・・・・・・・・・・・・・ Check for any abnormal vibration during machine operation. ・
Power ・・・・・・・・・・・・・・・・・・・Check for splits / breakage in power cord. Replace if damaged.
Weekly:
・
Clean the inside of the machine ・・Remove strap dust, paper dust, foreign matters with compressed air.
Clean the heater blade (top & bottom) with wire brush, steel wool or emory cloth (only after heater cools)
Blow out debris from the internal fan.
Monthly:
*Lube center press bar & slide table with oil (Part #4NA76)
To prevent injury please be sure the tabletops are replaced prior to
operation.
CHAPTER 6 ADJUSTMENT
Adjustment of
《
VR3
》
at insufficient tension
VR 3 is a volume that adjusts the completion of band reversal before tightening. VR3 is on the
control board.
● If tightening begins before the reverse rotation is completed, adjust VR3 by turning it clockwise.
● If reverse rotation is not completed even though the band is wrapped around the packing item,
turn VR3 counterclockwise to make adjustment.
800-821-2177
Service@MillerBevco.com or Parts@MillerBevco.com
www.MillerBevco.com
To Next Page
Loading...
