p. 7
Safety Alert Labels
Warning labels are seen where there is a potential risk of danger.
Carefully read the instructions on the Safety Alert Labels and follow them.
Replace missing or damaged safety labels with new safety labels immediately.
If safety labels are replaced with new labels, make sure new safety labels are attached in the same
location as the replaced labels.
WARNING and CAUTION are defined as follows:
WARNING indicates a potentially hazardous situation which,
if not avoided, could result in death or severe injury.
CAUTION indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate injury.
The alert labels shown below are attached to machine:
Placing Warning Labels
CHAPTER 3 INSTALLATION
Connect Power Cable ( for Outside North America )
1. Connect to appropriate Power Supply
Current··········· 15A
Voltage ··········· Single Phase 230V, 50Hz
Allowance of Fluctuation……. Voltage 198V～264V Frequency 50±3Hz
2. Use the appropriate plug according to the outlet.
WARNING : Electric shock.
Point with hazardous voltage that can result in electric shock.
CAUTION : High Temperature
Point with high temperature over 65℃ that leads to burns.
800-821-2177
Service@MillerBevco.com or
Parts@MillerBevco.com
www.MillerBevco.com
To Next Page
Loading...
