Strapack iQ400 - Operational Safety Procedures; Routine Maintenance and Safety

p. 6
Operation
 Read the Instructions carefully
 Do not use this machine other than to strap appropriate packages
 Never operate the machine when the table is removed
 Watch your steps around the casters and power cords.
 Dress appropriately to operate the machine.
 Do not touch the strap during the machine operation.
 Use caution to keep your body parts from getting caught between package and strap.
 Use caution to keep your body parts from getting caught when putting the loose strap back onto
the reel.
 Do not place liquid on the machine.
 Do not stand or sit on the machine.
 Remove jammed strap appropriately; do not pull by force.
 Do not touch the machine when your body has collected static.
Routine Maintenance & Adjustment
 Maintenance can only be done by a trained personnel.
 At the time of maintenance, the machine power should be turned off and the power plug should
be unplugged.
 After the power is turned off, wait until the following parts cools off.
 Heater
 Motor
 Control Board
 Transformer
 When you need to remove the cover to work on the IC Board, make sure that the remaining
electricity has been discharged.
**Right after the power switch is turned off, there is still some electric charge on the condenser of the
IC board. Therefore, handle it very carefully.
 When handling springs, be careful not to hurt yourself with the spring pressure.
 Dispose of the replaced parts appropriately, according to local trash regulations.
 When the maintenance is complete, replace the tables and outer panels and turn the power back on.
 Use only parts provided or approved by STRAPACK.
800-821-2177
Service@MillerBevco.com or Parts@MillerBevco.com
www.MillerBevco.com