2 Safety
2.1 Use for the intended purpose
These tools are intended for the strapping of packaged items such as packages, pallet loads etc. The
tools are intended for strapping with plastic packaging straps (polypropylene and polyester) (Section
7). Only use these tools as described in these operating instructions.
2.1.1 Possible misuse
● Do not use steel straps with these tools.
● Do not lift, hang or pull packaged goods by the straps.
● Do not modify tools without prior authorisation.
● Do not use these tools to compress goods.
2.2 Working safely
The operating instructions must always be available at the place of operation of the
strapping tool. They must be read and observed by all persons working with or in the
vicinity of the strapping tool.
Preventive and corrective maintenance on the tool may only be carried out by trained
personnel.
In addition to the operating instructions, the applicable local rules for accident preven-
tion and safe and professional work must be observed.
The operator or his supervisor is responsible for safe strapping and the correct strap selection (Section
7) for the package, depending on its dimensions, weight, edges and stability and the way it will be
transported and stored. Only the strap specications (Section 7) specied for the tool type should be
used. The tools should be adjusted appropriately for the strap used and the package (Section 4). The
operator is responsible for the correct tool settings and adjustments.
Wear protective equipment
► When operating the tool, wear eye and hand protection
(cut-proof gloves) and safety shoes.
2.3 Safety instructions
WARNING
Read all safety warnings and all instructions in this operating instructions and in
the battery charger operating instructions.
Failure to follow the warnings and instructions may result in electric shock, re and/or
serious injury. Following hazards can result in serious injuries:
Strap tensioning or strapping, danger of jamming and
crushing
Do not place hands or other body parts between the strap and
the packaged goods during the strapping process. Ensure that
there are no other persons in the hazard zone (1).
For an emergency stop in the case of danger (trapped
person):
● To release the strap tension (before welding), actuate the
rocker lever. In operating mode AUTO, also the tensioning
or welding button can be pressed again to stop strap
tensioning.
● After welding, cut the strap using a suitable tool (strap cutter).
To Next Page
Loading...
