Stratasys Objet24 - 1 Introduction; About this Guide; Installation and Training

Objet Desktop 3-D Printer Site Preparation Guide
DOC-04002 5 Rev. D2
1 Introduction
1.1 About this Guide
Thisdocumentprovidessitepreparationinformationandrequirements
foryourObjet3‐Dprintingsystemtoensureproperinstallationand
operation.Thecustomerisresponsibleforpreparingtheinstallationsite
accordingtotheinstructionsandguidelinesdescribedinthisdocument.
Thefollowingtopicsarecoveredinthisguide:
• PhysicalDescription
• Sh
ipmentandDelivery
• SiteRequirements
• FacilityRe
quirements
• SitePreparationChecklist
Important: Sincesitepreparation
activitiesmustbecompletedbeforethe
installationdate,itisimportant
forthecustomertoreadthisguide
thoroughlyandtocompletetheCustomerSitePreparationChecklistat
theendofthisguide.Oncompletion,thechecklistshouldbefaxedto
customer’sStratasys contac tperson.
Forspe
cialoperatingconditionsorifyouhaveanyquestionsaboutthe
sitepre
parationprocedure,contactyourlocalStratasys representative.
1.2 Installation and Training
Installationandtrainingtaketwoworkdays:
•Basicinstallationandadjustment—
Th
eseproceduresaredescribedintheprinterInstallationGuides—
Objet24/30printers:DOC‐14040
Alaris30printers:DOC‐0400
6
• Operatortraini
ngincludingpracticeundersuper
vision
—
CoverstheoperationandmaintenanceoftheObjetDesktop.