Manual English V16/04 page 14
The Hand-Bike is clamped to the wheelchair, the front-wheels are sitting on the floor.
Loosen the jam nuts of the spanner (Attention: left-hand and right-hand thread). The
length of the spanner can be changed by turning. As a guide value, the levers H2L and
H2R should be in the middle of the slot hole. The levers H2L and H2R must be in the
same position on both sides.
picture12
Models with automatic click-in adjuster
Open the jam nut of the automatic adjuster. The flap is opened. The length of the
automatic adjuster can be changed by turning the adjuster nut.
picture13
The longer the visible part of the snap-in slot, the higher the front wheels are lifting. A
good starting point is 1cm visible length of the slot. The setting must be the same on
both automatic adjusters. When the front wheels are lifted, both automatic adjusters
must snap-in place at the same time.
This is necessary for perfect functioning.
7.5 Straight tube City Kid
For moving the telescopic tubes just unsrew the Stopmuttern (nuts).
Attention: Neither open the bolt M1 (arow) nor the bolts IS 1
and IS 2.
To Next Page
Loading...