Problem Possible cause What to do
The receiver switches off
automatically.
Auto Standby function enabled. Disable auto standby. See section
7.3.7 for details.
Playback of video (or Timeshift) is
causing picture freeze/macro blocks
or similar distortion, especially on
HD content.
Read/write speed of your USB device
could be too low.
Make sure to use a USB storage
device with sufficient speed and
space. Pen drives (‘USB sticks’) may
not support sufficient speed.
9.0 TECHNICAL SPECIFICATIONS
Tuner
Tuner: Maxlinear MXL608
Input Impedance: 75 Ohm
Minimum Input Level: ≤ 40 dBuv (64 QAM)
≤ 44 dBuv (256 QAM)
Receiving Channel Range: 46 MHz ~ 862 MHz
Modulation: 64 QAM/256 QAM
Symbol rate: 3.6 M ~ 6.952 MS/s (64 QAM)
Video Decoder
Video decoder: MPEG -2 MP@HL, AVC/H.264 HP@L4.1, MPEG-4 ASP supported
Video resolution: 480i, 480p, 576i, 576p, 720p, 1080i, 1080p, By Source, By Native TV
Decoding & Video Out: PAL
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
Audio Decoder
Audio support: AAC/AC3+/PCM/Dolby® Digital Plus*
Audio mode: Stereo, Mono
*Dolby Digital Plus and the double-D symbol are registered trademarks of Dolby Laboratories.
Multimedia
Video playback: MPEG-1 and MPEG-2 encoded (mpg), VOB, AVI, MKV, TS, M2T, M2TS,
MPEG-4 and MOV*
Audio playback: MP3 and OGG*
Picture view: BMP and JPEG*
*STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on codec used, data bit rate and resolution (all
MPEG codec formats are supported).
System
Transponder: DVB-C (Digital Cable)
Main Processor: Ali M3812
Demodulator: Silicon SI2165
Memory: DDR II 64MB
FLASH size: 4MB
Connectors
Cable IN - IEC Female
Cable OUT - IEC Male (Loop through)
S/PDIF (coaxial)
HDMI
TV SCART
USB 2.0 port: DC 5 V, 800 mA (max.) supported
18
To Next Page
Loading...
Need help?
General
