PART 1 • English
10
5.3.3.3 Parental Setting
Set some programs to lock status. If a program is locked, the parental PIN code has to be entered
correctly before watching the locked program. Use UP/DOWN keys to select the channel you want
to lock and press OK to confirm.
5.3.3.4 Change PIN
PIN is Personal Identification Number. To modify the password, you need to enter the current PIN, a new 4
digit password and once again the new one for confirmation; the system password will be changed then.
5.3.4 System Information
Displays the software version information. Press OK/EXIT keys to return.
5.3.5 System Update
5.3.5.1 Update from Receiver to Receiver
You use this menu to update software from receiver to receiver. The System Update screen will appear.
When it is necessary to update the System, please follow these steps:
1. First power off both receiver, connect them with cross RS-232.
2. Then power on master receiver (master is receiver from which you will copy software)
and keep slave receiver off. Navigate in the menu of master receiver and select
“System Update – STB to STB”.
3. When the status displays “detecting slave STB”, power on slave STB, after the master
STB detects the slave, the master starts transmission and burns.
4. While transmitting and burning, it is very important to avoid other operations such as
power off because this may cause destruction of the data in the FLASH memory and the
receiver will need to be repaired.
5. When update is complete, first power off both STBs, then disconnect the RS-232 line.
Tips System Update just updates the software. The programs database will not be updated.
5.3.5.2 Update through PC to STB
1. Connect Computer to receiver (receiver must be power off) with a 9-pin cross cable (two females).
2. The computer will follow the steps below:
Start -> Programs -> Accessories -> Communications -> Hyper terminal
Then choose “COM1” or “COM2” according to which port you are using in the computer
and port setting as follows:
Bits per Second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
To Next Page
