PART 1 • English
10
5.3.3 Parental Control
In this menu, you can set Channel Lock status (ON or OFF), the Menu Lock status, Parental Setting and
change the PIN Code.
The default PIN code is 0000.
5.3.3.1 Channel Lock
Set the system Channel Lock to ON or OFF. If the channel lock is ON, the parental PIN code has to be
entered correctly before watching the locked channel.
5.3.3.2 Menu Lock
Press YES or NO, whether you want to lock the Menu or not and press OK to confirm. If the menu lock is
on, you need to enter your PIN for operations such as search program and set factory default.
5.3.3.3 Parental Setting
Set some programs to lock status. If a program is locked, the parental PIN code has to be entered
correctly before watching the locked program. Use UP/DOWN keys to select the channel you want to
lock and press OK to confirm.
5.3.3.4 Change PIN
PIN is Personal Identification Number. To modify the password, you need to enter the current PIN, a new 4
digit password and once again the new one for confirmation; the system password will be changed then.
5.3.4 System Information
Displays the software version information. Press OK/EXIT keys to return.
5.3.5 System Update
5.3.5.1 Update from Receiver to Receiver
You use this menu to update software from receiver to receiver. The System Update screen will appear.
When it is necessary to update the System, please follow these steps:
1. First power off both receiver, connect them with cross RS-232.
2. Then power on master receiver (master is receiver from which you will copy software) and
keep slave receiver off. Navigate in the menu of master receiver and select
“System Update – STB to STB”.
3. When the status displays “detecting slave STB”, power on slave STB, after the master STB
detects the slave, the master starts transmission and burns.
4. While transmitting and burning, it is very important to avoid other operations such as power
off because this may cause destruction of the data in the FLASH memory and the receiver
will need to be repaired.
5. When update is complete, first power off both STBs, then disconnect the RS-232 line.
Tips System Update just updates the software. The programs database will not be updated.
To Next Page
Loading...
