Strong SRT 6020 - Parental Control and PIN Management; System Information and Update

PART 1 • English
11
English
5.3.1.2 TV settings
You can set the
TV mode, Screen mode, Video output and Modulator setting.
n TV mode
In TV mode Screen press OK or RIGHT to select mode, press OK to confirm. If you don’t
know which standard your TV has, please select AUTO.
n Screen mode
In TV format Screen press OK or RIGHT to select 4:3 or 16:9, press OK to confirm.
n Video output
Press OK or RIGHT to select CVBS, RGB or S-Video, press OK to confirm.
WARNING: if RGB is selected then S-Video output is OFF.
n Modulator setting
The modulator setting screen will appear. Use
UP/DOWN to select RF Audio mode or
RF channel. Use LEFT/RIGHT to change the settings and press OK to confirm the settings
or EXIT to cancel.
5.3.1.3 Time Settings
If a broadcaster provides GMT, you can set the time using GMT, or set your own time by yourself. If
the GMT usage is ON then you have to set the Time Zone. If you set GMT Usage to OFF, Set Data
and Set Time item are displayed. To set the time value manually, move the cursor to the time item
and use the numeric buttons on the remote control.
5.3.1.4 Set Factory Default
Please be careful when using this function, because it will erase all the data and parameters you
may have set earlier to your receiver. Once you set the factory default you will have to re-install your
preferences and re-scan your channels. To reset your receiver to factory default, apply the following
steps:
Select Set Factory default and press OK. Confirm warning message with OK and press the OK key,
the receiver will return to its factory default state, and all user data will be deleted.
NOTE: Your PIN code will change back to the factory setting “0000”.
5.3.2 OSD Style
In this menu, you can set the Menu Colour, Transparency Level and Border Pattern.
5.3.3 Parental Control
In this menu, you can set channel lock status (ON or OFF), the menu lock status, parental setting and
change the PIN code.
The default PIN code is 0000.
n Channel Lock
Set the system channel lock to ON or OFF. If the channel lock is on, the user has to enter
the parental PIN code correctly before watching the locked channel.