PART 1 • English
12
n Menu Lock
Press OK to select whether you need the lock or not for the Menu, YES or NO, press OK to
confirm. If the menu lock is on, then for some operations such as search program and set
factory default, you need to enter your PIN.
n Parental Setting
Set some channels to lock status. If a channel is locked, the user has to enter the parental
PIN code correctly before watching the locked channel. Use the UP/DOWN keys to select
the channel you want to lock. Press the OK button to lock the channel.
n Change PIN
For modifying the PIN, you must enter the 4 digits PIN and confirm it again; the system
PIN will be changed to the new PIN.
5.3.4 System info
The system information displays information about your receiver such as software and User Interface version.
Compare the software version with the available in the internet in order to know if you have the latest version.
5.3.5 System Update
In this menu, you can select between “STB to STB” and “OAD”
n STB to STB software transfer.
1. First power off both STBs, connect them with cross RS-232.
2. Then power on master STB (master is STB from which you will copy software)
and keep slave STB off. Navigate in the menu of master STB and select
“System Update – STB to STB”.
3. When the status displays
“detecting slave STB”, power on slave STB, after the master
STB detects the slave, the master starts transmission and burns.
4. While transmitting and burning, it is very important to avoid other operations such
as power off because this may cause destruction of the data in the FLASH memory
and the receiver will need to be repaired.
5. When update is complete, first power off both STBs, then disconnect the RS-232 line.
n Over Air Download (OAD)
Select this option in order to update your receiver with the latest software version. Software update
service is available from satellites Astra 1C, 1E, 1F at 19E and Hotbird 1, 2, 3, 4 at 13E.
If your antenna is primed to Astra 1C, 1E, 1F at 19E then enter following parameters:
Frequency: 12603; Polarity: H (Horizontal); Symbol rate: 22000
If your antenna is primed to Hotbird 1, 2, 3, 4 at 13E then enter following parameters:
Frequency: 12476; Polarity: H (Horizontal); Symbol rate: 27500
Move menu focus to OK and press OK button on remote control. The receiver will check availability
of the software update on air and load the latest software, if available. Do not switch power off and
do not disconnect the receiver from the aerial during update process. Availability of the software
update is subject of local broadcast condition and may not work in all countries. Contact your
vendor to find out more about this function.
To Next Page
Loading...
