4
PART 1 • English
2.3 Rear Panel
Fig 2.
1. SAT IN To connect to the LNB of your satellite dish for reception of satellite
broadcast signal
2. SAT OUT To loop through the satellite signal to a second receiver
3. IR To connect the IR extender
4. AUDIO (L/R) To connect to the audio input of your HIFI or television
5. S/PDIF To connect to a digital or home cinema audio amplifier
6. VIDEO (RCA) To connect to the RCA video input of your TV or VCR using an RCA cable
7. TV SCART To connect to TV using a SCART cable
8. HDMI To connect to the HDMI input of your TV using a good quality HDMI cable.
9. Power switch To switch the mains power ON or OFF
10. Power cord The receiver requires a mains voltage of 100~240V AC 50~60Hz (auto
selecting). Please check the local power conditions before connecting
the receiver to the mains supply.
2.4 Remote Control Unit
Fig. 3.
1. q Turns the receiver ON/Standby
2. ! Mutes the audio output of the receiver
3. [0~9] Channel number and numeric value input
4. SAT Satellite selection in normal viewing and channel mode
5. TV/R Toggles between TV and Radio mode
6. MENU Displays the menu in viewing mode or to go back one step in the menu
7. EXIT Go back one step in the menu/cancellation of current process/exit
from main menu to viewing mode
8. pq Switches to the next/previous channel in viewing mode or moving the
highlight up/down in the menu
9. tu Increasing/decreasing of the volume level in viewing mode or
changing values of settings in the menu
10. OK Viewing mode: Displays the channel list. Menu: activation of the
highlighted item
11. FAV Toggles between available favourite groups and all channels list
12. EPG Viewing mode: Displays the EPG (Electronic Program Guide)
13. V+/V- Increasing/decreasing of the volume level
14. INFO Press once to display channel number/name and now/next info.
Press twice to display frequency/signal strength information.
15. AUDIO Displays the audio selection menu with selections for available
languages and audio modes
16. V.F Toggles between available HDMI screen resolutions
17. P+/P- Switches to next/previous channel in viewing mode
18. RED/RCL Toggles between the current channel and the previous channel in
viewing mode
To Next Page
Loading...
