LNB Freq Displays the corresponding values for the LNB type. 4 adjustments are
possible.
22 KHz Tone Not configurable at Universal LNB Type.
DiSEqC 1.0 If DiSEqC 1.0 is used, up to 4 positions can be linked to satellites.
DiSEqC 1.1 If DiSEqC 1.1 is used, up to 16 positions can be linked to satellites.
System If you set Sat CR, here you can choose a number from 1-9.
IF Channel If you are using Sat CR, you can set the IF channel here.
Center Frequency If you are using Sat CR, you can enter the corresponding frequency here.
Transponder Press OK to open the list of available transponders for the selected satellite to
check the reception or select for channel search on it.
If Transponder is highlighted, the channel search can be started on this TP by using the RED Search
button or just press OK, the GREEN Auto DiSEqC Search* button allows you to search for available
satellites in the existing antenna installation.
* This function can find available satellites within the already persisting installation. The preconfigured satellites are: Astra 19.2E, Astra 23.5E,
Astra 28.2E, HotBird 13.0E and Eutelsat 9.0E.
7.1.2 Motor Setting
If you are using DiSEqC 1.2 or USALS, you can install satellites which are received by a motorised dish.
For the correct installation and positioning of your motor, we recommend the support/advice of a
professional and experienced installer. Here you can configure the motor type and set the motor
position for a satellite that you want to receive.
Satellite Press OK to open the list of available satellites and select one by using the
pq or P+/P buttons, then press OK again for confirmation.
Transponder Press OK to open the list of available transponders if you like to set a specific
transponder for the selected satellite.
DiSEqC Motor Choose between DiSEqC 1.2 and USALS or Off. Per default it is Off because of
pre-defined setup for DiSEqC 1.0.
DiSEqC 1.2 selection
Move step-wise Press t u to move your antenna east or west. Move carefully until you see
that both signal beams have an acceptable reception level. When you find
the selected satellite, press and select Yes to save the position.
Move continuously Use this function to move quickly to a desired position by holding down
the t or u key, depending on the direction in which you want to move the
antenna. Also, be very careful with it, so you do not bump into obstacles.
Limit Press OK to open this sub-menu, which allows you to set the mechanical
limits for your motor. This is only necessary if your antenna is mounted which
means, that a wall, a tree or similar physical blockages could interfere with a
free movement of the antenna or motor.
Save to this position You can store this position between 0 and 63, OK can be used again as
described above.
Save/Recalculation With Save and Recalculate, you can set whether the position should be saved
or a new calculation should be made after setting this position.
Go to position Press OK to move the motor to the centre position. This is only necessary for
the first time to set the antenna correctly. Then you can also select a number
of a position you already have stored or check the antenna position.
14
To Next Page
Loading...
