What to do if my Strong TV Receiver has no picture or sound?
If your Strong TV Receiver shows no picture or sound, ensure your TV or amplifier has the correct HDMI input selected and that the resolution isn't higher than your TV supports. Also, verify that your TV is switched on.
What to do if my Strong SRT 8105 ECO TV Receiver remote control is not responding?
If your Strong TV Receiver remote control isn't working, make sure the receiver is plugged in and turned on. Aim the remote directly at the front panel, remove any obstructions, and replace the remote batteries.
Why does my Strong SRT 8105 ECO say no signal found?
If your Strong TV Receiver displays 'No signal found', check the aerial lead to ensure it's properly connected. Inspect the aerial for any damage or misalignment. If you're using an active antenna, ensure the receiver’s Antenna Power is switched ON or connect external power. If the issue persists, consult with your dealer to verify if you are out of the digital signal area.
What to do if I see a scrambled channel message on my Strong SRT 8105 ECO?
If you see a 'Scrambled channel' message on your Strong TV Receiver, the current channel is scrambled. Select an alternative channel.
Why does my Strong TV Receiver switch off automatically?
If your Strong TV Receiver switches off automatically, the Auto Standby function may be enabled. Disable the auto standby function.
How to improve digital reception on my Strong SRT 8105 ECO after moving it?
If you're experiencing poor digital reception on your Strong TV Receiver after moving it, the antenna signals may be too weak. Press the INFO button on the remote 2 or 3 times to view the signal bars and adjust the antenna for maximum reception, or rescan the channels.
What to do if the LED indicator is not lit on my Strong TV Receiver?
If the LED indicator on your Strong TV Receiver is not lit, check that the mains plug is properly connected.
General| Brand | Strong |
|---|---|
| Model | SRT 8105 ECO |
| Category | TV Receiver |
| Language | English |
Provides crucial safety guidelines for installation and operation to prevent damage and hazards.
Guidance on setting up the receiver, including recommended connections and symbols used in the manual.
Informs users about the default PIN code for security features and initial setup.
Explains the function of each button on the remote control for operating the receiver.
Instructions for connecting an antenna to the receiver for signal reception.
Guide for connecting the receiver to a TV using an HDMI cable for high-quality output.
Instructions for connecting USB storage devices for recording and media playback features.
Instructions for starting an immediate recording of the current program.
Procedures for installing channels, including auto scan and manual scan options.
To Next Page
