Strong SRT 8115 - 5 Quick Guide to Using Your Receiver

7
PART 1 • English
English
Region: Select your region where this receiver is used.
Subtitle: Select Normal to display subtitles per default, Select Hard of Hearing to show
HoH subtitles per default. Select Off to hide subtitles per default.*
Aspect Mode: Use this option to select the aspect ratio of your TV and the preferred
conversion method. Options are: Auto (automatic detection of aspect ratio),
4:3 Panscan (Displays 16:9 widescreen broadcasts full screen on your 4:3 TV),
4:3 letterbox (black bars on top and under the picture on a 4:3 TV) and 16:9
(use this setting for 16:9 TV sets).
Scan mode: Select All to store scrambled and free to air channels or select Free to store
only free to air channels. Note: Scrambled channels cannot be viewed with
this receiver.
Connection: Use this option to adjust the established connection to your TV set. Select
HDMI or TV SCART.
*Availability of DVB/HoH subtitles depends on the broadcast. If such subtitles are not supported, then most likely subtitles can be activated via Teletext
if available.
When all settings have been made, move the highlight to OK and press OK to continue.
NOTE: Wrong region selection can lead to missing channels or channels being
stored at wrong positions in the channel list.
The receiver will now advance to the Aerial Adjustment screen.
This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to alter and use tu to change values. The
following settings are available:
Antenna Power: Set to On if you use an active antenna. When set to On, 5 V will be present at the
ANT IN connector of the receiver. Select Off for passive antennas.Beeper: Select
On for an audible indication of signal reception. Off turns the beeper off.
Beeper: Select On for an audible indication of signal reception. Off turns the beeper
off.
Channel No.: Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
When all settings have been made, press OK to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver switches
to viewing mode.
TIP: If the Welcome menu should not appear after switching on the receiver for
the first time, reset the receiver to factory settings by pressing the MENU
button and selecting Load Factory Setting in the submenu Tools. DEFAULT
PIN: 1234.
5.0 QUICK GUIDE TO USING YOURRECEIVER
We at STRONG understand that you can’t wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.