Strong SRT 8115 - Tools

15
PART 1 • English
English
Wakeup Date: Use the 0~9 buttons to input the date for the timed event.
Wakeup Time: Use the 0~9 buttons to input the start time.
Duration: Use the 0~9 buttons to input the timer duration.
When all settings are according to your wishes, use pq to move the highlight to Save and press OK
to confirm. To quit the timer without saving your settings, move the highlight to Cancel.
7.3.5 ParentalLock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
enter a new PIN code in the Parental Lock menu.
Use pq to select Parental Lock from the System Setup menu and press OK to proceed. You will be
asked to enter your PIN code. DEFAULT PIN: 1234
Menu Lock: Locks the installation menu. You can set Menu Lock to On or Off.
Parental Rating: Choose between: Off, 4 years and up to 18 years. Channels with a parental
rating above the chosen age will be protected with a PIN code (if available in
your local broadcast.)
New Password: Enter your new PIN code (4 digits) here.
Confirm Password: Re-enter your PIN code here to confirm.
7.3.6 OSDSetting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD Timeout: Sets the time after which on screen banners and messages disappear. The
range is 1~10 seconds.
OSD Transparency: To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press OK to clear all OSD settings and reset to default values.
7.3.7 AutoStandby
Auto Standby is a new feature that helps you reducing power consumption. When set to 30Min/1
Hour/2 Hours or 3 Hours, the receiver will switch to standby if it doesn’t receive any commands during
this time. Set Auto Standby to Off to deactivate the automatic standby function.
7.4 Tools
Press MENU in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press OK or u to enter.
Use pq to highlight the submenu of choice and press OK proceed.
Press EXIT to leave.
7.4.1 Information
This submenu shows receiver specific information such as hardware version and software version. It
also displays our web address www.strong.tv. Please have the Information screen on hand when you
call our hotline. The person who answers your call might ask for the information given in this screen.
7.4.2 Load FactorySettings
This option allows you to reset the receiver to factory settings, which clears all stored channels.