Strong SRT 8208 - Usage of External USB Devices; Your Receiver; Pin-Code; Front Panel

1.5 Usage of external USB devices
 It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specications, the playback with your receiver might not work properly.
 If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
specications might exceed the supported output of your receiver (5 V/500 mA). If so, please
connect your USB HDD to an according external power adapter.
 STRONG cannot guarantee compatibility with all types of USB storage devices.
 It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
 Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the
USB device via your receiver. Formatting requires entering the PIN code
 STRONG cannot guarantee the playback of all les although extensions are listed, as it depends
on le size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 PIN-CODE:
At First Installation, you will be asked to enter a new PIN code. Set the PIN code and make a note of it.
2.2 Front Panel
Fig.1
1. Power button: Switch the receiver to Standby or On.
2. CH+/CH- To change channels without using the remote control
3. LED Mode indicator:
RED indicates that the receiver is in STAND-BY mode. GREEN indicates that the
receiver is in OPERATING mode.
4. IR sensor: Point your remote control towards this sensor. (Hidden)
5. USB: Connector for USB devices.
2.3 Rear Panel
Fig.2
1. ANT IN To connect to your antenna for the reception of broadcast signal.
2. S/PDIF Coaxial To connect your receiver to a digital audio amplier.
3. HDMI To connect your receiver with your TV set using a HDMI cable.
4. TV SCART To connect your receiver with your TV set using a SCART cable.
5. Power Cord Your receiver requires a voltage of 220~240 V AC (Auto-selectable), 50/60 Hz
+/-5%. Check the local power specication before connecting your receiver to
the wall outlet.
2.4 Remote Control
Fig.3
1. q Turns the receiver On/Standby
2. INFO Shows the actual channel information
3. SLEEP No Function
5
English