Mixing cooling fluid additive with water
Follow the instructions on the cooling additive container. If you need more information, see:
www.struers.com
Note
Do not overfill the tank.
Avoid spilling when you move the tank.
6.2 Control panel functions
Button/LED Function
On/Off
Green LED: Standby mode.
Red LED: Unit error (after power-up or pump failure/overload).
Pump status
Green LED: Pump is energized.
Red LED: Pump error (not connected or pump failure/overload).
Resume
Use this button to manually reset the control unit after power up or pump
failure/overload.
Note
You can only reset the control unit using the Resume button if no
other signal is applied at the signal input connector.
7 Maintenance and service
Proper maintenance is required to achieve the maximum up-time and operating lifetime of the
machine. Maintenance is important in ensuring continued safe operation of your machine.
The maintenance procedures described in this section must be carried out by skilled or trained
personnel.
Safety Related Parts of the Control System (SRP/CS)
For specific safety related parts, see the section "Safety Related Parts of the Control System
(SRP/CS)" in the section "Technical data" in this manual.
Technical questions and spare parts
If you have technical questions or when you order spare parts, state serial number and
voltage/frequency. The serial number and the voltage are stated on the type plate of the machine.
22 Cooli System
7 Maintenance and service
To Next Page
Loading...