12. If you observe malfunctions or hear unusual noises, switch off the machine and call technical
service.
13. In case of fire, alert bystanders and the fire brigade. Disconnect the electrical power supply.
Use a powder fire extinguisher. Do not use water.
14. Always switch off the electrical power supply and remove the plug or power cable before
dismantling the machine or installing additional components.
15. The machine must be disconnected from the electrical power supply before any service.
16. Struers equipment must only be used in connection with and as described in the Instruction
Manual supplied with the equipment.
17. If the equipment is subjected to misuse, incorrect installation, alteration, neglect, accident or
incorrect repair, Struers will accept no responsibility for damage to the user or the
equipment.
18. Dismantling of any part of the equipment, during service or repair, should always be
performed by a qualified technician (electromechanical, electronic, mechanical, pneumatic,
etc.).
2.4 Safety messages
Struers uses the following signs to indicate potential hazards.
ELECTRICAL HAZARD
This sign indicates an electrical hazard which, if not avoided, will result in death or
serious injury.
DANGER
This sign indicates a hazard with a high level of risk which, if not avoided, will
result in death or serious injury.
WARNING
This sign indicates a hazard with a medium level of risk which, if not avoided,
could result in death or serious injury.
CAUTION
This sign indicates a hazard with a low level of risk which, if not avoided, could
result in minor or moderate injury.
CRUSHING HAZARD
This sign indicates a crushing hazard which, if not avoided, could result in minor,
moderate or serious injury.
HEAT HAZARD
This sign indicates a heat hazard which, if not avoided, can result in minor,
moderate or serious injury.
2 Safety
Cooli System 7
To Next Page
Loading...