PPrroocceedduurree::
1. Apply the brake. Push on the product to make sure that the brakes work.
2. Raise the litter to the highest position.
3. Using a small floor jack, raise the side of the base frame off of the floor approximately four inches.
4. Using a drill with a 3/16” drill bit, drill out the rivets on the bottom of the pedal to be replaced.
5. Using a pop rivet gun and rivets, install the supplied pedal.
6. Lower the product to the floor.
7. Verify the proper operation before you return the product to service.
JJaacckk rreeppllaacceemmeenntt wwiitthhoouutt ccoommpprreessssiioonn sspprriinngg
TToooollss rreeqquuiirreedd::
• 3/8” wrench
• 1/2” socket
• 1/2” wrench
• 3” extension
• Need nose pliers
PPrroocceedduurree::
1. Apply the brakes. Push on the product to make sure that the brakes work.
2. Raise the litter to the highest position.
3. Raise the Fowler backrest.
4. Raise the siderails to the up and latched position.
5. Using a 3/8” wrench, remove the bolt in the litter support tube above the black bellows on both ends of the product.
6. Lift the litter off of the jack shafts and set the litter aside.
NNoottee -- Litter top removal requires two people.
7. Lower the jack to the lowest position.
8. Remove the base hood.
9. Using a 1/2” socket and a 1/2” wrench, remove the four bolts, washers, and nuts that hold the jack support straps to the
base frame.
10.Using needle nose pliers, remove the two cotter pins on the pump link.
11.Remove the pump link.
12.Using a 1/2” socket, a 1/2” wrench, and a 3” extension, remove the four bolts that hold the jack base to the base frame.
13.Remove the jack from the base frame.
14.Reverse steps to install the supplied jack.
15.Verify proper operation before you return the product to service.
JJaacckk rreeppllaacceemmeenntt wwiitthh ccoommpprreessssiioonn sspprriinngg
TToooollss rreeqquuiirreedd::
• 3/8” wrench
• Need nose pliers
• Slotted screwdriver
1061-009-002 Rev A.0 15 EN
To Next Page
Loading...
Need help?
General
