Strymon blueSky - Page 23

pg 23
blueSky - reverberator
Configuring blueSky to Use MIDI (cont.)
STEP 3  SET MIDI OUT MODE
1 Press and hold the FAV footswitch while connecting power to the
pedal� Once both LEDs flash, release the footswitch�
2 Turn the LOW knob to select what kind of MIDI data is sent from
blueSky to other MIDI devices� Both LEDs will flash momentarily to
indicate status�
• OFF: RED (default) - No MIDI messages are sent out of blueSky�
• THRU: BLUE - Incoming MIDI messages are sent to the MIDI Out
without any additional MIDI messages generated by blueSky�
• SEND CC, PC, OTHER: WHITE - MIDI CC, PC, and Sysex messages
generated by blueSky are all sent to the MIDI Out�
• SEND CC, OTHER: GREEN - MIDI CC and Sysex messages gener-
ated by blueSky are sent to the MIDI Out�
• SEND PC, OTHER: PURPLE - MIDI PC and Sysex messages gen-
erated by blueSky are sent to the MIDI Out�
• SEND OTHER: AMBER - Sysex messages generated by blueSky
are sent to the MIDI Out�
3 Press either footswitch to store the MIDI Out mode and exit�