pg 22
blueSky - reverberator
STEP 2 SET MIDI CHANNEL (CONT.)
4 Press either footswitch to exit and store your MIDI Channel setting
and begin using blueSky�
NOTE: A simple way to check that communication is working is to send
CC #102 with a value of 127 when the ON footswitch is bypassed� This will
enable the ON footswitch on if MIDI is properly connected and configured�
NOTE: If you are only sending data to blueSky using the Strymon MIDI EXP
cable, the MIDI OUT mode must be set to OFF� (See page 23 for details on
configuring the MIDI OUT Mode�)
NOTE: MIDI Channel assignment is not saved per Favorite setting or MIDI
preset�
To Next Page
Loading...
