Riverside - Multistage Drive
®
pg 29
MIDI – Configuring Riverside to Use MIDI (cont.)
This determines what kind of MIDI data is sent out by Riverside. Note
that if you are only sending MIDI data to Riverside – the most common
configuration – the MIDI Output mode must be set to OFF.
Step 3 – Set MIDI Output Mode
Turn the MIDDLE
knob to select what
kind of MIDI data is
sent from Riverside
to other MIDI devices.
Both LEDs will flash
momentarily as the
mode is changed.
GREEN - ON: Using
Riverside’s knobs and
switches generates
MIDI messages that are
sent out of Riverside.
AMBER - THROUGH: Incoming MIDI messages are sent out of
Riverside without any additional MIDI messages generated by
Riverside.
RED - OFF (default): No MIDI messages are sent out of Riverside.
Press and hold the FAVORITE footswitch
while powering up the pedal. Once both
LEDs flash, release the footswitch.
1
TIP: A simple way to check that communication is working is to
send CC #10 with a value of 127 when the FAVORITE footswitch is
off. This will turn the FAVORITE footswitch on if MIDI is properly
connected and configured.
2
To Next Page
Loading...
