Studer Innotec SA
RCC-02/-03
User manual V4.4.0 25
10.8.5.3.4 Loading an Xtender master file {5034}
If your installer provides you with a file of parameters for your installation, you can load it by means
of this menu. Insert the SD card and launch the loading by pressing the key SET. Caution, the various
operations carried out by this process take some minutes.
10.8.5.3.5 Load Xtender parameters preset {5045}
Libraries of predefined parameters are available for specific applications (such as Solsafe). From this
menu you can load one of these libraries. You can also combine various libraries.
If two or more libraries handle the same parameter, the value of the last library loaded
is used.
10.8.5.4 INSTALLER - Formatting the SD card {5047}
This parameter will completely erase the SD card’s current contents.
10.8.5.5 Starting the update {5061}
This parameter will force an update using the contents on the SD card.
10.9 ADJUSTING THE CONTRAST
The adjustment of the contrast allows the display to be adjusted in terms of lighting and to a reading
position that allows excellent visibility.
10.10 BACK-LIGHTING {5007}
10.10.1 Backlight modes {5093}
With this parameter you can determine if the lighting of the remote control should always be turned
on (ON), always be turned off (OFF) or automatically lit for short periods when pressing any one of its
buttons (Delayed).
10.10.2 Duration of the back-lighting {5009}
This configuration allows you to determine after how much time of inactivity the back-lighting will
switch off.
10.10.3 Red back-lighting if the Xtender is OFF and if there is a fault {5026}
If the Xtender is stopped by a fault (battery undervoltage, overload, etc.) the back-lighting flashes
red.
10.11 EXTENDED AND SPECIAL FUNCTIONS {5021}
10.11.1 Choice of the display by default {5073}
With this parameter you can choose the display by default that comes up when exiting from a menu
or while connecting the remote control.
10.11.2 Inactivity period before returning to the standard display {5010}
This configuration allows you to determine the time after which the display returns to the basic display
if no key is pressed.
To Next Page
Loading...
Need help?
General