EasyManuals Logo

Studer RCC-03 User Manual

Studer RCC-03
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
Studer Innotec SA
RCC-02/-03
42 V4.4.0 User manual
14.8 MANAGEMENT AND BATTERY CYCLE {1137}
These configurations are intended to adjust the battery charge cycle to the data supplied by its
manufacturer. The basic battery cycle is described in the Xtender manual.
Caution: the Xtender charger is only meant to charge lead batteries.
Note: Incorrect values may lead to early ageing or even destruction of the batteries.
For further information, contact your battery supplier who will give you the correct values.
The graphic presentation of the battery cycle shows the options for linking the various phases:
The bulk charge and floating phases cannot be deactivated. If the conditions for starting a new
battery charge cycle are fulfilled, the bulk charge phase starts immediately. In order to remove the
voltage spike set the Absorption voltage {1156} to be identical to the Floating voltage {1140}.

Table of Contents

Other manuals for Studer RCC-03

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Studer RCC-03 and is the answer not in the manual?

Studer RCC-03 Specifications

General IconGeneral
BrandStuder
ModelRCC-03
CategoryExtender
LanguageEnglish