7-45
Built-In
Built-In
(600-
(600-
2
2
)
)
Series
Series
Component Access / Removal
#3758407 - Revision B - August, 2006
Freezer Evaporator Fan Assembly (685-2, 695-2)
The rear flange of the freezer evaporator fan assembly
fits into a slot in the rear evaporator bracket. The front
is secured by screws through the front flange into the
front evaporator bracket.
To remove freezer evaporator fan assembly, the juice
can rack, upper front panel and evaporator front cover
will first need to be removed, then (See Figure 7-116):
1. Extract the screws which secure fan bracket to front
evaporator bracket.
2. Pull assembly out of slot at rear evaporator bracket
and disconnect fan motor electrical leads.
Freezer Rear Duct (685-2, 695-2)
The bottom of the freezer rear duct is secured by slots
in the side flanges fitting over pegs at the bottom of
each shelf ladder. At the top, screws hold the rear duct
to the lower evaporator cover assembly.
To remove the air duct (See Figure 7-117):
1. Extract mounting screws at top front flange.
2. Pull top forward and lift up off of pegs.
Lower Evaporator Cover Assembly (685-2, 695-2)
The lower evaporator cover assembly has pegs at the
back that fit into pockets in rear wall. Snap pins toward
front sides slide into pockets in the side walls.
To remove the lower evaporator cover assembly, the
evaporator front cover/light assembly and rear duct
must first be removed, then (See Figure 7-118):
1. Pull snap pins out of pockets in side walls.
2. Disconnect lighting electrical leads.
3. Pull assembly forward.
Figure 7-118. Lower Evaporator Cover
Pull snap pins from pockets
Figure 7-117. Rear Duct
Extract screws
Figure 7-116. Compartment Thermistor
Evaporator
Fan Assy
To Next Page
Loading...
Need help?
General
