Sub-Zero 632-2 User Manual

Built-In
Built-In
(600-
(600-
2
2
)
)
Series
Series
Installation Information
2-7
#3758407 - Revision B - August, 2006
Figure 2-11. Molding Removal
D
o
o
r
P
a
n
e
l
D
o
o
r
D
o
o
r
Stick tape to
center of
trim molding
and pull
Extract screws and
handle/trim from door
Slide door panel into
door frame
Figure 2-12. Handle/Trim Removal Figure 2-13. Door Panel Install
Door Panel Installation (All Framed and Overlay Models)
1. Using a piece of tape stuck to magnetic trim molding center, pull trim molding out at midpoint to expose
handle/trim mounting screws (See Figure 2-11).
2. Extract mounting screws and handle/trim from door (See Figure 2-12).
3. Slide door panel into door frame (See Figure 2-13), then reinstalling handle/trim and magnetic trim molding.
NOTE: On Models 685/F-2, 685/O-2, 695/F-2 & 695/O-2, the glass well bezel will also need to be removed from
door before sliding door panel into door frame. See Bezel removal instructions in section 7 of this manual.
NOTE: If door panel is less than 1/4” thick, a filler panel must be installed behind door panel.

Sub-Zero 632-2 Specifications

General

Brand	Sub-Zero
Model	632-2
Category	Refrigerator
Language	English