SubGear xp-3h - Water Contacts; Dive.log Dedicated Software Application

10
• Switch on the backlight
• Activate the safety stop timer
(dive mode only, in depths < 6.5m / 21ft)
Gauge mode (stopwatch):
• Restart
Diving with 2 or 3 mixtures:
• Initiate switch to gasd, gas 1 or gas 2
•
Interrupt switching process
• Confirm switch to gasd, gas 1 or gas 2
2.4 Water contacts
On submerging in water the water contacts switch on Subgear XP-3H automatically.
WARNING
If you have chosen the option "Water contacts off" ("set 1", ->70), Subgear XP-3H will turn on
with a delay of up to 1 minute into the dive. This will affect functioning of the computer.
Make sure that the computer is on before starting the dive.
2.5 Dive.Log dedicated software application
With Dive.Log you can configure Subgear XP-3H, transfer dive data to a personal computer and
graphically display the data. To start the communication, turn on Subgear XP-3H and place it so that
its infrared port is in front of the infrared interface. If Subgear XP-3H detects an infrared device within
range
appears.
Configuring Subgear XP-3H
To configure Subgear XP-3H, select "Dive Computer Settings" under "OPTIONS" on the main menu
bar of Dive.Log after having established communication between your PC and Subgear XP-3H. The
following window will appear:
System and operation