SubGear xp-3h - Current Depth; O; MIX; Tank Pressure; Maximum Depth; Temperature; Set Max Depth Reached

24
Functions during the dive
If a dive lasts longer than 199 minutes the dive time display starts again at 0 minutes.
4.4.4 Current depth / O
2
% mix
Current depth
O2% mix
Nitrogen loading bar
Current depth is given in 10cm increments in metric setting and 1ft
increments in imperial setting.
At a diving depth of less than 0.8m (3ft) the display shows " – – – ".
DEPTH
DIVE TIME
The O2% mix is diplayed as long as CNS O2% = 0 and
no ascent speed is indicated.
Depth is calculated using the pressure and density of the water and is
slightly effected by salinity. When diving in fresh water, use setting: Set1 ->
Salt. off
4.4.5 Tank pressure / Maximum depth / Temperature
CNS O2%
Tank pressure
Tank pressure is the default information shown on the diving display. Other
values can be displayed by pressing the right button, but tank pressure will
show again after a timeout of 5 seconds.
> Max depth
> Temperature, O2 mix
> Temperature , Time , O2 mix
> Max depth
When diving with multiple gas mixtures, XP-3H displays always only the pressure of the gas where
it is connected by the hose.
4.4.6 Set max depth reached
S
L
O
W
DEPTH
DEPTH
NO ST
NO ST
OP
OP
DIVE
DIVE
TIME
TIME
4s
WARNING
If the max depth set with Dive.Log or “set1” has been reached (default 40m/130ft) and the depth alarm is turned
on, the depth display will  ash.
Ascend until the depth stops  ashing.