SUBITO ARGON 18 - PAS Sensor Installation; Position PAS Sensor; Connect PAS Sensor Cable

21
11.4 pas sensor Installation
1. Insert the cable of the PAS sensor
(SKU: 81232) from the hole in the
interior of the drive side chainstay.
2. Exit the cable through the hole
under the bottom bracket.
3. Push the PAS sensor in the
bottom of the PAS cavity.
4. Hand tighten the M4 x 5mm
setscrew (SKU: 81254) to secure
the PAS sensor. Do not apply
grease on the thread.
5. Insert the grommet (SKU: 80826)
to cover the cable insertion hole.
6. Connect the PAS sensor cable
to the matching connector on
the battery, you will hear
a clicking sound.
81232
80826
81254
M4 x 5mm
4
4Nm
4
3Nm
3Nm
2
2Nm
3
3Nm
5
9.5Nm
4
5Nm
2
HT
8
12Nm
8
35Nm
2.5
2Nm
2
0.5-1Nm
40Nm
4Nm
T25
T25