Subsite 910R - Page 50

50 910R/950R/950T/970T - OPERATION
LOCATE LINE: ACTIVE LOCATION
50 910R/950R/950T/970T - OPERATION
LOCATE LINE: ACTIVE LOCATION
To set up transmitter for use with live power adapter:
1. Verify that transmitter (1) is turned off.
2. Connect live power adapter (2) to the transmitter.
3. Connect live power adapter black lead to the ground stake
(4).
4. Connect live power adapter red lead to live power conductor
(3).
5. Turn on transmitter.
6. Select frequency greater than 8 kHz (29 kHz is preferred).
7. Adjust power level as needed.
8. Check battery level.
IMPORTANT: When finished locating the line, turn off transmitter,
disconnect live power adapter red lead from live power conductor,
disconnect live power adapter black lead from ground stake, and
disconnect live power adapter from transmitter.
To set up transmitter for use with live power adapter:
1. Verify that transmitter (1) is turned off.
2. Connect live power adapter (2) to the transmitter.
3. Connect live power adapter black lead to the ground stake
(4).
4. Connect live power adapter red lead to live power conductor
(3).
5. Turn on transmitter.
6. Select frequency greater than 8 kHz (29 kHz is preferred).
7. Adjust power level as needed.
8. Check battery level.
IMPORTANT: When finished locating the line, turn off transmitter,
disconnect live power adapter red lead from live power conductor,
disconnect live power adapter black lead from ground stake, and
disconnect live power adapter from transmitter.