8 | Sub-Zero Customer Care 800.222.7820
Anti-Tip Bracket
WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
WARNING
To avoid a hazard due to instability of the appliance,
it must be fixed in accordance with the instructions.
Use the centerline locating holes to position the anti-tip
bracket in the center of the opening. The bracket must be
positioned 24"
(610) from the front of the opening to the
back of the bracket. This depth will increase to 26"
(660) for
a flush installation. Failure to properly position the anti-tip
bracket will prevent proper engagement.
CENTERLINE
LOCATING HOLES
Anti-tip bracket
Installation
DRAWER
SLIDE
Door removal
Drawer removal
Preparation
Doors and drawers can be removed for ease of installation.
Door and drawer removal is not required. To remove a
door, refer to the illustration below. To remove a drawer,
pull the drawer out to full-extension. Apply forward pres-
sure to the front of the drawer slide, and pull up and back
on the drawer handle. Refer to the illustration below.
To Next Page
Loading...
Need help?
General
