Section 8
ILLUSTRATIONS AND PARTS LIST
55
8.3 MOTOR, COMPRESSOR, FRAME AND PARTS
key part
number description number quantity
1 motor, 150HP (I) 02250116-106 1
2 nut, hex 3/4”-10 825212-665 4
3 washer, springlock 3/4” 837812-188 4
4 shim set, motor mtg 020293 2
5 element, coupling 406631 1
6 hub, coupling 407988 1
7 hub, coupling 407987 1
8 guard, coupling 225907 1
9 capscrew, hex GR5 3/8”-16 x 1 1/4” 829106-125 3
10 washer, reg 3/8” 838206-071 3
11 unit, compressor (II) 1
12 frame 02250122-522 1
13 nut, hex 3/8”-16 825206-337 3
14 capscrew, hex GR5 3/4” x 2 1/4” 829112-225 4
15 washer, wide 3/4” 838312-174 4
(I) Motor may vary. Consult factory with machine serial number.
(II) There is an exchange program whereby a remanufactured compressor unit can be obtained from Sullair
distributors or the factory at less cost than the owner could repair the unit. For information regarding the
unit exchange program, contact your nearest Sullair representative or the Sullair Corporation.
The shaft seal is not considered part of the compressor unit in regard to the two year warranty. The nor-
mal Sullair parts warranty applies. For shaft seal repairs order repair kit no. 600889-001.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
