PRINCIPLE OF OPERATION SECTION 5
126
5.64 HOW TO CHANGE WATER /
GYLICOL TEMPERATURE
SET POINT:
Press and buttons at the same time.
is seen on the screen. Factory set code is
10
By using arrows set the code to 10
Press and see
Press and see
Press and see
is the minimum water / gylicol
temperature set value.
By using arrows change the
setting.
Factory setting for is 25 F
Press and see
is the maximum water / gylicol
temperature set value.
By using arrows change the
setting.
Factory setting for is 35 F
Press and then press to exit.
To Next Page
Loading...
