SECTION 5 PRINCIPLE OF OPERATION
89
5.45 WIRING DIAGRAM—CONTROL CIRCUIT RC 150 (110/120-1-50/60-A, 208/230-1-50/60-A)
A01: CONTROL CIRCUIT TRANSFORMER
A10-1: RUNNING LAMP ON CONTROL PANEL (GREEN)
A10-2: REMOTE CONTROL RUNNING LAMP (GREEN)
A10-3: DUAL BUTTON CONTROL LAMP (GREEN)
A11-1: STAND-BY LAMP ON CONTROL PANEL (RED)
A11-2: REMOTE CONTROL STAND-BY LAMP (RED)
A20: DRAIN VALVE
K01: COMPRESSOR RELAY
EMR4: PHASE PROTECTION RELAY
F10: CONTROL CIRCUIT PROTECTION
F11: DRAIN VALVE PROTECTION
F12: FAN PROTECTION
F13: ALARM PROTECTION
K01: COMPRESSOR MOTOR RELAY
K10: FAN MOTOR RELAY
K20: DRAIN TIMER
K30: ALARM RELAY
K30-1: EKONOMIZER RELAY
K40: WATER MOTOR RELAY
RL1: ESD2 CONTACT
RL2: ESD2 ALARM CONTACT
S02-1: START BUTTON ON CONTROL PANEL
S02-2: REMOTE CONTROL START BUTTON
S03-1: STOP BUTTON ON CONTROL PANEL
S03-2: REMOTE CONTROL STOP BUTTON
S04: REMOTE CONTROL SWITCH
S10: FAN PRESSURE CONTROL
S11: HP-BP SECURITY CONTROL
S20: SECURITY THERMOSTAT
S30-1: FAN PROTECTOR I
S30-2: FAN PROTECTOR II
To Next Page
Loading...
Need help?
General
